T5 燈DIY可行嗎?

海洋生物/水族用品/魚缸製作/設計施工
維護保養/天然海水/餌料生物/水產批發
[這篇文章最後由DUKE在 2003/06/06 09:09pm 第 1 次編輯]

下面引用由AC2003/06/06 05:10pm 發表的內容:
那是 80w 1對1的!
Update: 1對2 = 21W, 28W NT$ 700.00 ----------- 220V
35W, 54W NT$ 800.00 ------------220V
1對1 = 21W, 28W, 35W & 54W NT$ ~400.00 --- ...
高功率的瓦數好像是24w,39w,54w,80w
 
在 Osram 的網站找了一些有關 T5 燈管資料願於大家分享.
*FH - T5*
FH-T5.gif

*FQ - T5*
FQ-T5.gif

Question:
What is the difference between the types FH and FQ for the T 5 (16 mm) fluorescent lamps?
Answer:
FH stands for Fluorescent High Efficiency. These lamps offer extremely high luminous efficacies up to 104 lm/W. FQ stands for Fluorescent QUINTRON. Linear T 5 (16 mm) fluorescent lamps have four lamp lengths and are 5 cm shorter than the lengths of the T 8 (26 mm) lamps as a basis (55, 85, 115 and 145 cm), i.e. a FH lamp and a FQ lamp have the same length with different wattages (e.g. same length of 115 cm for FH 28W and FQ 54W).
FH (14 to 35 W) lamps are lamps with a very high luminous efficacy with values up to 104 lm/W, FQ lamps (24 to 80 W) are lamps with an increased lamp wattage and higher luminous flux values per lamp for direct and indirect lighting, high rooms and for industrial lighting. FH can be used for offices and good architectural design with a high energy efficiency. FQ lamps are therefore used where a high luminous flux value per lamp unit is required, as the luminous efficacy of the FQ lamps is around 90 lm/W.
The use of the respective design FH or FQ is dependent on the type of system and on the luminaire type.

FQs are particularly well-suited for direct/indirect lighting, high rooms and for industrial lighting. FH can be used for offices and good architectural design with a high energy efficiency.
 
AC兄提供的FQ-T5應該即是高功率燈管..
AC兄:請教一下,第2張圖FQ-T5安定器的價格是多少ㄋ?
如不方便,能否短訊提示一下..
如價格合理,應該離動工時間不遠了..^ ^
 
Hi, Kymco 老弟,
今天人家休息沒得問耶. >_<
 
下面引用由AC2003/06/07 11:17am 發表的內容:
Hi, Kymco 老弟,
今天人家休息沒得問耶. >_<
哈哈!!我做機車做到時間都忘了..cc
 
各位同好,
沒錯! 上次問到價錢是 FH 型的.
目前正在詢FQ價中, 請稍安勿躁.
一有消息自當貼上. ^_^
 
各位大大..目前我自行改裝T5燈..改裝內容如下:M牌FL燈具.拆除原有FL零件..將燈管固定夾裝置于反射板上(固定燈管用)再將1對2安定器固定在燈殼內部..插上燈管就可完成...不好意思..因我不會PO圖..所以無法讓大家看.....
FH型...統稱..低管壓低功率
FQ型...統稱..高管壓高功率
其燈管分高.低管壓..安定器皆為電子式.分高功及低功..又有1對1..1對2..1對3..等的分別..當然還有110V.220V種....
燈管有歐絲朗.奇異.飛利浦.台灣.大陸..等多家在生產..
燈管色溫有2700K.3000K.3500K.4000K.6000K.6500K...等.因每家生產各有差異....
 
小莊大大:
請問零件及燈管要花多少coco....
 
我不知你問的是哪一種ㄟ??規格粉多ㄟ?因我之前是做照明業的...
 
如果是 (54w 左右 , 120 公分, 藍燈,)x2 , 安定器, 總共約要多少?
香港 ezreef 賣的安定器不知道會不會比較好?(它現在是ph8.4廣告商
直說應無妨)
 
改裝時,燈管兩端的插座可以續用嗎? sorry,沒有甚麼概念
好像有人說 T5 的光度比同w數的 T8高不了多少,是不是跟
安定器有關
 
返回
上方 下方